Rust-Oleum Filler Primer is a hi-build formula that fills in minor imperfections in the surface and improves topcoat adhesion and appearance. This product is suitable for use on metal, wood and fiberglass surfaces. Filler Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with a wider finger pad reduces fatigue caused by continuous spraying.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of 2-In-1 sandable and filler primer spray

The hi-build formula fills in minor imperfections.
Sands smooth for the ultimate finish.
2 in 1 Primer features an advanced spray system that allows you to spray at any angle
A comfort spray tip with wider finger pad.
Stops Rust formula.

NOTE: When dry, surface can be immediately recoated, top coated or wet sanded. For best results allow 2-4 hours before dry sanding.

How to Apply 2-In-1 Sandable And Filler Primer Spray

Suitable Environmental Conditions

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that, when heated, exceed 200°F (93°C) or galvanized metal. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

Make your surface ideal

Wash the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and dry with a clean cloth. Remove loose paint and rust with a wire brush or sandpaper. Lightly sand glossy surfaces.

Application

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. Apply 2 or more light coats a few minutes apart. Do not use near open flame.

Properties of 2-In-1 Sandable and Filler Primer Spray

Brand	Rust-Oleum
Resin Type	Modified Alkyd
Pigment Type	Titanium Dioxide and Inorganic Pigments
Solvents	Acetone and Aromatic Hydrocarbons
MIR	1.20 Max
Practical Coverage at Recommended DFT	10-12 sq.ft./can
Fill Weight	340 Grams
Recommended Dry Film Thickness (DFT) Per Coat	1.5-2.5 mils (37.5-62.5µ)
Dry Times at 70-80°F (21-27°C) and 50% Relative Humidity	10 minutes to touch and re-coat aytime after 10 minutes
Dry Heat Resistance	93°C
Shelf Life	5 years
Flash Point	-156°F (-104°C)
Safety Information	For additional information, see MSDS
Technical Data Sheet	Click here

Rust-Oleum Automotive 2-In-1 Sandable And Filler Primer Spray Paint - Gray

Rust-Oleum Automotive Universal Bonding Primer Spray Paint

Rust-Oleum AUTOMOTIVE High Heat Primer Spray Paint - Gray