Rust-Oleum Watco Satin Finishing Wax

Watco Satin Wax is a liquid solvent-based wax that leaves a rich, soft satin luster while providing an additional level of protection and water resistance to oil-finished or bare woods. Use Watco Natural Satin Wax for light-colored woods and the Dark Stain Wax for dark-colored woods, or mix them for a medium toned wax. Satin Wax is recommended is suitable for use on furniture, trim, paneling, or any interior bare or oil-finished wood surface. It is NOT recommended for floors or exterior surfaces.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of Watco Satin Finishing Wax

• Formulated for bare or oil-finished woods
• Provides an extra level of protection
• Wipe-on and buff off

How to Apply Watco Satin Finishing Wax

Surface Preparation

Allow any previously applied oil or stain on wood surface to dry 72 hours before applying Watco Satin Wax for Finishing.

For unfinished bare wood surfaces, sand using 150-220 grit sandpaper and remove all sanding dust with a vacuum or a rag dampened with mineral spirits. If a filler or putty is used, make sure it does not contain wax and allow for enough time to dry thoroughly.

Application

Use only when air (ambient) temperature is between 60-90°F (16-32°C) and relative humidity is below 85%. Allow for longer dry times during damp and humid conditions. Mix material thoroughly before application. Stir occasionally during use. Spread a thin, even coat of Watco Satin Wax with a clean cloth. Wait 10 minutes, wipe clean and dry. Polish with a soft cloth.

For more information, please check technical data sheet.